READ THIS CAREFULLY BEFORE PROCEEDING
In case you're dumb: this ONLY works on FW 7.5x. If you are on 6.72, go
here. If you
are on 7.00-7.02, go here.
If you are on a higher firmware (e.g. 9.00), you can test the Webkit from
here.
- Click on MIRA, HEN or GOLDHEN, depending on your personal habits. In about 20 seconds you'll get an
alert saying "You're all set!", followed by "There is not enough free system memory". This means that everything
has gone well. Note: if using Mira, the screen will go dark for a dozen of seconds.
If something went wrong during the process, you may get an alert saying "Jailbreak failed! Reboot your
PS4 and try again.". In this case you must reboot your PS4, preferrably without closing the dialog
box.
If the system hangs for more than a minute (may require more time on slow Internet connections), reboot
your PS4 and try again.
If the system crashes (looks like instant powerdown), press the power button on the PS4 (NOT on the
gamepad) until it turns on again, then retry.
- If you get a "There is not enough free system memory" message without any pop-ups, then it means that the webkit
exploit has failed. Click OK and retry.
- For advanced users: To load your own payloads using NetCat, run NETCAT and send the
payload to TCP port 9021 (9020 for the legacy version).
Credits: Synacktiv team for the WebKit exploit, @theflow for vulnerability disclosure & hints, <anonymous> for 7.5X kernel dump, @codedwrench for ps4-kexec (Linux loader) kernel offsets
This exploit does many crash and hang. Sometimes you even have to retry 10 times to get the jailbreak.
This error is not going to harm your console.
Success rate here is about 10%, so don't worry and continue...
